hoogldirty.blogg.se - Clockx will not shutdown

#CLOCKX WILL NOT SHUTDOWN HOW TO#

The LED on the wireless receiver will blink 4 times and then turn off, indicating that the signal from the wireless sensor has been acknowledged

While the red LED is solid and the Wireless Receiver is in search mode, press and holds the spindle on the wireless sensor.

The red LED in the center of the Wireless Receiver will turn on and stay solid for 10 seconds, indicating that it is in search mode, searching for a signal from a wireless sensor.

After the receiver's green and black wires have been connected, restore power to the controller.

#CLOCKX WILL NOT SHUTDOWN HOW TO#

How to initialize communication manually between wireless Receiver and Sensor The Wireless Solar Sync Sensor can be addressed to talk to any number of Wireless receiver/controllers within range.Solar Sync has a two-year Manufacturers warranty from the date code on the back of the module.Approved for direct burial and sunlight exposure (UV). Wiring: 18 AWG/ 0.8 mm or 20 AWG/0.8 mm diameter minimum from the sensor to the module.Maximum distance from sensor to controller: 200 ft./60 m of wire.Then check the Solar Sync Seasonal Adjustment value on the controller. Allow the Solar Sync to take baseline measurements for 3 days.Make all wiring connections before powering up the host controller.On initial set up, program in the peak station run time duration that you use in the hottest months of the year regardless of what time of year it is.Make sure the controller's Seasonal Adjustment value is set to 100% when programming initial run times.Changes only occur to the Seasonal Adjust which in turn changes the station run time. The controller Start Times and Water Days do not change. The current value shown is actually a 3-day rolling average. The Solar Sync takes hourly readings and every night at midnight changes the controller Season Adjust to a new value based on recent weather.Greenhouse, Nursery, and Open-Field Irrigation.